Texas Instruments XDS522, Руководство по установке

Страница: 22 / 52

Step 3: Setting Jumpers on the Target Cable Adapter Board (Optional)
1-8
1.5 Step 3: Setting Jumpers on the Target Cable Adapter Board (Optional)
If you are using the target cable adapter board, you must reset jumpers on it.
If you are not using the target cable adapter board, skip this step.
To configure the XDS522/XDS522A emulation system, reset jumpers JP1 and
JP2 on the target cable adapter board. See Figure 1–6 for the location of these
jumpers.
The settings depend on the device you are using. To determine the correct set-
tings, see the configuration information on the disk included with your device
configuration kit.
Figure 1–6. Target Cable Adapter Board
JP1
JP2