Terex Evoquip Bison 120, Руководство по эксплуатации, Страница: 142 / 224

9 Maintenance
Operations Manual
Bison 120
20-07-2018
Page 9-34
Revision 2.0
4. Remove the filter cartridge and dispose off safely.
5. Replace with new filter cartridge element of same specification.
6. Hand tighten the filter housing back on to engine.
7. Remove the lockout and tag out.
(b) Changing the Engine Oil Filter (Tier 4 Engine)
PROCEDURE
1. Observe all safety warnings.
2. Shut down the machine and implement the lockout and tag out procedure.
3. Clean around the oil filter cap so that foreign matter does not enter. Remove the oil filter cap.
4. Place a container for receiving the oil beneath the oil pan and the oil filter.
5. Remove the oil filter drain plug and drain the oil.
1
2
Figure 9.22 - Engine Oil Filters (Tier 4)
6. Remove the center bolt and remove the oil filter case and element (Item 2).
7. Apply a thin layer of clean engine oil to the oil gasket of the new element.
8. Reinstall the new element, oil filter case and center bolt. Torque the center bolt to 39.2 - 49.0
Nm (4.0 - 5.0 kgfm/29 - 36 lbft).
9. Tighten the oil filter drain plug to 19.6 - 29.4 Nm (2.0 - 3.0 kgfm/14 -22 lbft).
10. Remove the oil level gauge and carefully fill the specified engine oil into the oil filler.
11. Install the oil level gauge and the filler cap, and start the engine 5 minutes after refueling,
and then let it idle. At this time, check whether any oil leak is found around the oil filter and
drain plug.
12. Stop the engine, wait for 10 - 20 minutes, and then check the oil level with the oil level gauge.