EN
OPERATION
2100/2120/2140/2150/2200/2260 (07–03)
6
2.
Insert the tab at the bottom of the solution tank
into the tank support slot located near the handle
base as shown. Secure the top of the tank with
the upper support bracket as shown. Then tighten
the upper support bracket screws (Figure 3).
FIG. 3
3.
Connect the chain to the solution control lever.
Connect the solution feed tube to the solution
supply connector on the machine base (Figure 4).
FIG. 4
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
MACHINE SETUP
INSTALLING PAD DRIVER / PAD / BRUSH
FOR SAFETY: Before leaving or servicing
machine, unplug cord from wall outlet.
1.
Pull the handle height adjustment lever and raise
the handle to the upright position. Carefully tilt the
machine backwards and rest the handle on the
floor (Figure 5).
FIG. 5
2.
For pad installation, center pad driver on pad and
tap with hand to secure (Figure 6).
NOTE: Consult your authorized distributor for pad and
brush recommendations. Use only manufacturer
supplied or approved pad drivers and brushes.
FIG. 6
