Tempest Tacit 8 56.050L, Руководство пользователя

Страница: 7 / 75

Tacit 8 User Manual 7
Introduction
Thank you for purchasing a Tempest enclosure! We have worked hard to provide you with the very
best product available for its purpose, and we shall continue to do everything possible to ensure
that it works well for you for many years to come.
Please read this manual before starting work!
In the event of difficulty, please contact your Tempest reseller or Tempest direct:
info@tempest.biz
+1 818 787 8984
We will do everything we can to help you get the very best results from your Tempest enclosure.
IMPORTANT: Safety Advisories
•
All installation and rigging work done must where applicable be designed and built in
accordance with norms and standards of the local authority having jurisdiction of the
installation site. It is the responsibility of the installer to obtain such approvals as may be
required to achieve full compliance.
•
All electrical work must be carried out by a suitably licensed electrical contractor in full
compliance with local electrical standards.
•
Lifting: some enclosures and the equipment inside them may be heavy. Use properly
rated lifting equipment where appropriate and never attempt to carry out work with
fewer than the number of workers needed to lift safely.
•
It is the responsibility of the installer to ensure that all local building, safety and electrical
codes are strictly adhered to in the installation of this enclosure. Tempest Lighting, Inc.,
its employees and agents are in no way responsible for damage arising from failure to
follow either the instructions in this manual or building, safety and electrical codes
prevailing at the installation location.
•
Do not attempt to install or operate the enclosure before fully reading and understanding
this manual
•
Never allow anyone who has not read this manual to open the enclosure or perform
maintenance on the projector within.
•
Never leave the enclosure unattended when open.
•
Always make sure all bolts and latches are tight and safety locks are in place after
performing any form of maintenance on the unit.
•
Do not open any electrical boxes until power has been shut off to all supply lines to the
enclosure (including the one powering the projector).
•
Do not open the enclosure in wet weather.