Tempest Tacit 8 56.050L, Руководство пользователя

Страница: 41 / 75

Tacit 8 User Manual 41
Control Interface
LED Indicators
Heater ON (Green)
Heater is ON, to maintain lower temperature level or to prevent condensation
ON (Amber)
Enclosure is temporarily outside the Goldilocks zone, and DEC is working to restore it
Fan ON (Green)
Lamp is ON, or Temperature is HIGH and fan is cooling enclosure. OR: Lamp is OFF, and
internal temperature =/> UPPER TEMP setting
ON (Amber)
Fan should be ON, but no status response received. Tacit and Zen systems: check the
integrity of the yellow status fan wire.
ON (Red)
No fan detected at initialization. Tacit and Zen systems, check that the yellow (status)
and brown (PWM) wires are not crossed or disconnected.
Lamp On ON (Green)
Current sensing shows lamp is ON
Lamp hour counter is running
OFF
Current sensing shows lamp is OFF
Lamp hour counter is not running
Lamp Relay
ON (Green)
Lamp relay is closed (normal)
Projector power receptacle is energized
ON (Red)
Lamp relay is open due to over-temperature event. Projector power receptacle is
isolated.
Temp FLASHING (Green)
Temperature is below lower temp setting
ON (Green)
Temperature is in normal range
ON (Amber)
Humidity is above target limit
ON (Red)
Temperature is above top setting
FLASHING (Red)
Temperature is above Trip level
Projector power is isolated
Data OFF
Data not used in present Mode. OR DEC4 is in RDM + DMX Control Mode and no valid
data packet has been detected.
ON (GREEN)
Good data packet received.
ON (RED)
RDM + DMX Control Mode: Data Fail. A previously good data signal has failed.