Blizzard Enclosure User Manual
page 14
3.1 Fan- Only Versions:
Remove the electrical cover inside the
enclosure. You will see the fan wires
already terminated to the connector
block on the rear panel.
Pass the AC feeder wires through the
rear panel and terminate to the
connector block, using one of the wiring
diagrams below.
Feed the projector power cable through
the grommeted hole in the electrical cover, and terminate as shown in the wiring diagrams
below.
Replace the electrical cover, taking care not to pinch any of the power wires.
Use the second cable entry to run projector signal and control cables to the projector, as
specified by the projector manufacturer.
Wiring Diagrams
120V Dual Feed
120V Single Feed
230V Dual Feed
230V Single Feed
L N
L N
PROJECTOR
FAN
L N
L N
PROJECTOR
FAN
L N
L N
PROJECTOR
FAN
L N
L N
PROJECTOR
FAN
