Blizzard Enclosure User Manual
page 26
DMX
(Not used in BASIC Mode)
OFF – No DMX received (Basic Mode)
ON (RED) – DMX Fail
ON (GREEN) – Good DMX or RDM data packet received. Note that in Monitor Mode the DMX
indicator will only be green when RDM packets are being received. In this case a RED LED
is not indicating DMX failure, just that no data is being received from the RDM monitor.
Control Interface Operation
The Control Interface is normally LOCKED.
To UNLOCK, hold
ESC
and
OK
together for 5 seconds.
You are now in the
CONTROL MENU
Use the arrow keys to scroll up and down the menu.
Press
OK
, to enter a menu item, then the arrow keys to set
the item parameter, or to scroll to the next menu level.
Use
ESC
to back up a level, and
OK
to confirm settings.
To LOCK, hold ESC for 5 seconds. Menu will time out after ten minutes.
CONTROL MENU
SET DMX ADDRESS
(in Monitor, DMX or Service modes)
Select a DMX starting address in the range 001 to 510
1 – Lamp Relay
In Service Mode an addition two slots are available
2 – Fan Relay
3 – Heater Relay
Note that the DMX control is designed using a SAFETY pile-on Logic. So the DMX input can
only override automatic settings in a safe manner. For example, if the enclosure has
switched off the lamp relay due to an over-temperature condition, the DMX input cannot
switch it on, if the fans are running because of Overtemp, the DMX input cannot turn
them off, and so on.
SET DMX MODE
From the Front Panel, this menu item allows the user to check (and if necessary change)
the RDM mode.
BASIC
Standalone operation, no DMX/RDM (factory default)
MONITOR
Standalone, plus support for RDM remote configuration and monitoring
CONTROL
Monitor, plus use of a single DMX address to control Lamp relay
SERVICE
Monitor, plus use of three DMX slots to control Lamp, heater and fan
Important: Please ensure that the DEC3.2 is NOT left in Service Mode.
