Teltonika MVC100, Руководство пользователя

Страница: 22 / 34

22 | P a g e
Command Users class Example Action
alarm off Administrator,
user
alarm off Camera disables “On event stream” and sends
confirmation SMS to the sender.
alarm? Administrator,
user alarm? Camera sends “On event stream” status: enabled or
disabled.
cb Administrator cb The camera allows remote listening in on surrounding area
by making the phone call. Sending SMS with “cb”
command breaks current call
cu Administrator cu The camera sends SMS message with information about
current or last “area listener” user.
up? Administrator,
user up? The camera sends SMS message with sender's user class
ipaddr? Administrator,
user ipaddr? The camera sends SMS message with its IP address to the
sender.
power? Administrator,
user power? The camera sends SMS message with power status (battery
or mains power used).
2.4 Settings
2.4.1 E-mail & FTP
This section describes how to configure FTP and E-mail settings. Settings can be found at the
E-mail and FTP tab in camera WEB configuration page.
Pressing Save button updates camera with new settings immediately. These settings are stored
in permanent memory.
To enable email function following settings must be configured:
Figure 16. E-Mail settings.
SMTP server – the domain name or the IP address of the email SMTP server.
Secure connection – check the box to enable SSL for sending an email. Contact email service
provider in order to find out if the SSL is required for sending an email.
User name –Enter your user name of the email account.
Password – Enter your password of the email account.
Sender’s email address – Enter emails address which is assigned to the user name and
password.
CC email – Enter secondary recipients email address or multiple addresses separated by space,
comma or semicolon which will be added to the sent e-mail as Carbon Copy (CC).
Subject – Enter the desired subject of the email.
Note: Receivers email addresses are set in the Users Management section.
Note: to test the E-mail function press Generate button in the Stream & Events section. Do not forget
to enable and setup
On event stream section.