20 |
P a g e
2.3.1.2
On event stream
Figure 14.
Event
video stream
settings.
Enable
– Check the box to enable stream on event feature.
Events
– Select desired events which will trigger the camera. Event trigger can be: Contact1,
Contact2 which are located on the back panel of the camera. Connect external sensors (e.g. door, PIR)
to these contacts.
Resolution
– Select the desired resolution of on event stream [VGA/QVGA/QQVGA].
Quality
– Select display video quality [Basic/Medium/Normal/High/Best].
Frame rate
– Set frame rate for video stream. Checking Single shot check box allows to record
single shot.
Video format
– Displays allowable video format [MJPG or MPEG4].
Send to
– Select video stream send destination. To send video to E-mail or FTP their settings
first must configured. If the Output option is selected camera will close relay contact on 2-pin terminal
block. This terminal maybe connected to the light source. Triggering the camera will cause relay to
work as light switch for turning the external light on.
Pre-alarm
– The camera has ability to send stream which was before the event. It is made by
continuously storing required amount of information in camera‟s internal memory. Set the time in
seconds to define how much data must be stored. This function is very useful when checking to see
what happened immediately before a trigger.
Send-alert
– select this option to enable sending alert message. Message will be sent if an event
on contacts Contact1 or Contact2 will be generated. The SMS messages will be sent to all the mobile
phones that are in the user‟s lists. Users list if configured in Users management section.
Post-alarm
– Set the time in seconds how long after the event camera sends the stream.
Output duration
– Camera has integrated relay switch, which may be turned on event. Set the
time to define relay closed contact time.
Pressing Save button updates camera with new settings immediately. These settings are stored
in permanent memory. In order to test if camera transmits defined stream on event to E-mail, FTP or
Output the Generate button may be pressed. It is a useful feature allowing to easily system testing.
Note: camera can capture up to 40 frames. Please choose correct frame rate and Pre-alarm and
Post-alarm values in order to do not exceed the 40 frames limit.