FlexSym-ONT205-Installation-Guide
Page 20 of 38
o
Screwdrivers or driver bits to fit the wood or machine screws, dry wall
anchor screws, or masonry anchor screws that will be used in mounting
the ONT to a wall or other surface
o
Medium slot screwdriver
•
Wire cutter/stripper (for installations using remote bulk DC power or the
alternate AC adapter)
•
Power drill and drill bits sized appropriately for screw pilot holes, and drywall and
masonry anchor holes (sizes required will depend on fastener selection)
•
Digital multimeter with test leads (a DMM with only basic functions will do)
Supplies
The following supplies should cover a typical FlexSym 205 installation (supplies are
locally sourced):
•
Fasteners - Select screws, drywall anchors, and masonry anchors of the
appropriate size for the light weight of the ONT and optional Wall Mounting
Bracket (<2 pounds). Make sure that the heads are large enough so they do not
pull through the mounting holes of the bracket.
•
Extra Phoenix-type pluggable terminal connectors (5.08 mm pitch 2P) to fit the
ONT DC 54V power connector (one connector is packed with the ONT)
•
Molex connectors (8-pin) to fit the ONT UPS connector
•
Cable ties (Nylon and Velcro) and vinyl electrical tape
•
Sharpie or other fine-point permanent marker
