FlexSym-ONT205-Installation-Guide
Page 19 of 38
Warning: Do not bend the fiber optic cable to a diameter smaller than 7.5cm/3
inches. Doing so may damage the fiber or prevent the signal from passing through
properly.
FlexSym ont205 - Maximum PoE Power
DC Input
DC Max PoE Power Output
150-W AC Adapter (optional) ~140 W
85-W AC Adapter (optional)
~??? W
Remote bulk DC power
~ 90 W (US Electrical Code limits remote low voltage DC power to 100 VA)
Note:
The AC adapters and AC line cords are optional accessories, available from
Tellabs separately and at extra cost. Contact your Tellabs sales representative for
details and ordering information.
Tools and Supplies
The tools and supplies needed for a FlexSym 205 installation vary depending on the
location and type of installation.
Tools
The following list of tools should cover the typical FlexSym 205 installation:
•
Screwdrivers or driver bits
o
Small slot screwdriver (1/8 inch) for attaching DC power wiring to a DC
power connector pigtail (for installations using remote bulk DC power or
the alternate AC adapter)
