Tellabs 8820 MSR, Установка системы

Страница: 81 / 88

Tellabs 8820 Multi-service Switch Router System Installation B-1
APPENDIX B
Setting Boot
Parameters
The Multi-service Operating System is pre-installed and ready
for system configuration after powering up the 8820 MSR.
During system bootup, check to ensure that the hardware LEDs
are reporting proper status. The client IP address, IP mask, and
IP gateway address must exactly match those configured on the
IP management port.
This appendix contains:
❑
A condensed boot sequence example, in which the validation
and loading progress of software components and modules
have been omitted (to avoid showing repetitive information).
Only the final confirmation of the validation and loading
progress is shown.
❑
Procedure for performing a manual bootup configuration,
which should only be performed if your system does not
boot up properly, or if the installed software is corrupt, or
missing. For additional assistance contact
Tellabs Advanced
Data Products Technical Support
(Table 2-2)
.
❑
Commands you can use at the command prompt (M>) to
view current boot settings, modify settings, then restart the
boot sequence.