9
2.5.3 Relay output settings
Control through phone call:
if enabled, the relay becomes controllable remotely
through phone call.
In the following rows all events are specified for which can be enabled to activate the
relay on occurrence.
01. Z1 Alarm
(alarm in zone 1)
02. Z1 Restore
(restoration of alarm in zone 1)
…
12. Z6 Restore
(restoration of alarm in zone 6)
13. Arm
(arming)
14. Disarm
(disarming)
15. Test report
(sending test report message)
16. Battery Low
(low battery voltage)
17. Battery OK
(low battery voltage restored
)
Max. ON time
: it can be set for the relay (
RELAY1
), how long to remain activated
after activation by an event or a phone call (0-254 seconds). If value
255
is set, the
relay will operate in bistable mode, which means if it has been activated, it will not
deactivate itself, can only be deactivated through phone call (if enabled) or will
deactivate on disarm if "
Turn off Relay 1 on Disarm
" is set (this function does not
operate in "
Always Armed
" mode). If value
0
is set, the relay will never operate.
Beep on Arm/Disarm
: if enabled, activates Relay1 impulsely on Arm/Disarm, one
impulse on Arm and two on Disarm. This function can be used to indicate arming and
disarming by connecting e.g. a siren or a flashlight to this output.
Relay1 indicates GSM fault
: Relay1 can be set to become activated on GSM
network fault by enabling this function. In this case the relay remains activated during
the fault.
Attention!
If the module is configured for "
Always Armed
" mode with the relay set
bistable and the "
Control through phone call
" function is disabled, in case of relay
activation, it cannot be deactivated only through the programming software!
