Teledyne T300, Руководство по эксплуатации, Страница: 264 / 426

Troubleshooting and Service Teledyne API – Model T300/T300M CO Analyzer
262
SAMPLE RANGE=50.0 PPM CO= XXXX
<TST TST> CAL SETUP
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
EXAMPLE
DIAG I/O 0) EXT_ZERO_CAL=OFF
PREV NEXT EDIT PRNT EXIT
Press PREV and
NEXT to cycle through
the signal types.
DIAG I/O 1)EXT_SPAN_CAL=OFF
PREV NEXT JUMP EDIT PRNT EXIT Press JUMP to go
directly to a specific
signal
(see Appendix A for a list
of all I/O SIGNALS)
DIAG I/O JUMPTO: 0
0 0 JUMP ENTR EXIT
Toggle to set
location No. of the
VAR to JUMP to.
DIAG I/O JUMPTO: 22
2 2 JUMP ENTR EXIT
DIAG I/O 22) RELAY_WATCHDOG=ON
PREV NEXT JUMP OFF PRNT EXIT
Pressing PRNT will send a formatted
printout to the serial port and can be
captured with a computer or other
output device.
SETUP X.X ENTER PASSWORD:818
8 1 8 ENTR EXIT
DIAG SIGNAL I/O
NEXT ENTR EXIT
On status signals this
button toggles the
signal ON / OFF.
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
Figure 12-2: Example of Signal I/O Function
Note Any I/O signals changed while in the signal I/O menu will remain in effect
ONLY until signal I/O menu is exited. The Analyzer regains control of
these signals upon exit. See Appendix A-4 for a complete list of the
parameters available for review under this menu.
06864B DCN6314