Teledyne T300, Руководство по эксплуатации, Страница: 205 / 426

Teledyne API – Model T300/T300M CO Analyzer Calibration Procedures
203
Only appears if either
the O2 or CO2
Sensors are installed.
M-P CAL CO SPAN CONC:40.0 Conc
0 0 4 0 .0 0 ENTR EXIT
SAMPLE GAS TO CAL:CO
CO O2 ENTR EXIT
SAMPLE RANGE=50.0PPM CO=XX.XX
< TST TST > CAL MSG SETUP
M-P CAL RANGE=50.0PPM CO=XX.XX
<TST TST> ZERO SPAN CONC EXIT
SAMPLE RANGE TO CAL:LOW
LOW HIGH ENTR EXIT
The CO span concentration value
is automatically default to
4 0.0 Conc .
If this is not the the concentration of
the span gas being used, toggle
these buttons to set the correct
concentration of the CO
calibration gas.
EXIT ignores the new
setting and returns to
the previous display.
ENTR accepts the new
setting and returns to
the
CONCENTRATION
MENU.
Only appears if the DUAL or
AUTO range modes are selected.
Use these buttons to choose the
appropriate range.
Repeat entire procedure for each
range.
I
MPORTANT
I
MPACT ON
R
EADINGS OR
D
ATA
For this Initial Calibration it is important to independently verify the
PRECISE CO Concentration Value of the SPAN gas.
If the source of the Span Gas is from a Calibrated Bottle, use the exact
concentration value printed on the bottle.
06864B DCN6314