Installation instructions
│
T24
│
Chapter 9: Configuration menu
On the Receiver
On the Transmitter
1. Power the receiver up.
LED 1 is flashing (red)
.
2. Press and hold the
Cap sensor
button until LED1 stops flashing.
LEDs 2–5 flash (fast).
3. Release the
Cap sensor
button.
LEDs 1–5 flash (slow).
The receiver is now in registration
mode.
If no register command is received
within 30 seconds, the receiver
will exit registration mode.
1
4. Make sure that the
Stop
button is
pressed.
5. Twist and release the
Stop
button.
The initial start-up logo is
displayed.Battery indicator(s) light
(s).The display shows:
[Session
Selection]
.
6. Enter
Menu mode
(see
Menu mode (no PIN code required)
"
).
7. Navigate to the
[Register]
menu
using the
Up/Down
buttons.
8. Press the
Select
button to enter.
9. Choose a location for the receiver
to be registered in using the
Up/Down
buttons.
10. Press the
Select
button to select.
A + sign is displayed in front of
the selected location.
11. Press the
Back
button to accept.
The display shows:
[Registration
in progress…]
When the transmitter's register command is received, …
On the Receiver
On the Transmitter
LEDs 1–5 flash (fast).
The display shows:
[Confirm
registration on the receiver]
.
12. Press the
Cap sensor
button for at
least 2 s.
LEDs 1–5 flash three times.
The display shows:
[Registration
successful. Transmitter was
registered in HY-RX-xxxxx]
.
The transmitter is now registered.
1
It is also possible to exit registration mode by briefly touching the receiver's cap sensor button.
IM-PM-TX101-EN-v08
53
