Installation instructions
│
T24
│
Chapter 8: Operation
8 .5 Log the transmitter in to a receiver
1. Make sure that the
Stop
button is pressed.
2. Twist and release the
Stop
button.
(missing or bad snippet)(missing or bad snippet)
The display shows:
[Session Selection]
NOTE: Should the display show a warning message on zero position for the
control switch or joystick, release the affected controls in order to proceed.
If the controls are not released, the transmitter will block the
corresponding inputs and display the following warning message:
[Inputs
have been blocked. IO board 0X: 0xXXXXXXXX]
.
Enter the
Menu mode
and clear the locked inputs before proceeding with
the login procedure (see
).
3. Press the
Select
button to select one or more receiver(s) for the session.
The display shows:
[Select one or more items]
and the list of the
registered receivers. Selected receivers are marked with a + sign.
Select/change one or more receiver(s)
Keep selected receiver(s)
4. Choose a receiver in the list using
the
Up/Down
buttons.
5. Press the
Select
button to select.
A + sign is displayed in front of
the selected receiver.
6. Repeat steps 4–5 if necessary.
7. Press the
Back
button to accept.
The display returns to the start
screen:
[PUSH START BUTTONS]
8. Press both
Start
buttons to start
the session.
The buzzer emits a beep.
The
display shows:
[Logging in…]
.
9. Press the
Stop
button to exit the
session.
The display shows:
[Ending
session…]
The login settings are now stored/
saved in the transmitter.
4. Press the
Back
button.
The display returns to the start
screen:
[PUSH START BUTTONS]
5. Proceed to step 8
IM-PM-TX101-EN-v08
43
