Tektronix TekRanger 2 TFS3031, Руководство по обслуживанию

Страница: 29 / 272

Operator Information
1–6
TFS3031 TekRanger/TekRanger 2 Service Manual
Laser Output Port
The test fiber connects to the Laser Output port located on the side panel. Laser
light is emitted into the test fiber from the Laser Output port.
If both singlemode and multimode Laser Output ports are installed, the
singlemode port is in top position and multimode port in bottom position. If one
Laser Output port is installed, it will always be in the bottom position whether
singlemode or multimode.
Singlemode instrument options are 04, 06, and 10. Multimode instrument
options are 01 and 03.
Connector Adapter
The connector adapter attaches the test fiber to the Laser Output port. Connector
adapters must be installed on the Laser Output port before use.
NOTE
. The type of connector adapter and connector on the test fiber must match
for proper mating. See page 1–105 for a list of connector adapter options.
Connector Adapter Installation and Removal
Connector adapters are keyed for proper mating with the Laser Output port.
To install a connector adapter, align the keyed elements, slide the connector
adapter onto the Laser Output port, and turn clockwise until the connector
adapter is finger tight (see Figure 1–1 on page 1–6).
To remove a connector adapter, unscrew it counterclockwise and pull it straight
off of the port.
Connector adapter
Figure 1–1: Connector Adapter Installation
Laser Output Port and
Connector Adapter