System Customization
Assign Transmitters to Locations and Residents
In this step, stationary transmitters that were added to the system during system
setup will be added to locations within the facility. This step also covers adding mobile
pendant transmitters to residents added to the system in the previous step. During this
step, refer to the programming worksheet that was created during system setup. The
programming sheet should contain all the device numbers as well as the locations where
the devices were installed in the facility. These device locations should correspond to
locations that were added to the facility map.
Assign Pendant Transmitters to Residents in the Event Monitor
1. Click on the
Registers
button in the lower right hand corner of the Event Monitor.
2. Choose
Transmitters
from the page selection pane, and select the pendant
transmitter to be assigned to a resident from the list of transmitters.
3. Click
Edit
to unlock the transmitter settings for editing and choose the resident
to associate with the transmitter from the drop-down
Resident
menu.
4. Click
Apply
to assign the transmitter to the selected resident.
5. Once the settings have been applied, place a call from the transmitter that was
just programmed and verify that it is associated with the correct resident.
6. Label the transmitter so that it can be given to the assigned resident, ensuring
that it does not get confused with other pendant transmitters.
Assign Pendant Transmitters to Residents in the Config Tool
1.
With the Event Monitor software running, open the Config Tool software. When
prompted, choose
Load Configuration from System
on the splash screen.
If the Config Tool is already running, choose
File>Load Configuration from
System
to ensure that the most current system configuration is open for editing.
2. In the page selection pane, choose
Transmitters
and select a pendant transmitter
from the transmitters list.
3. In the
Details
pane, click
Edit
.
4. In
Details>Assignment
, choose a resident name from the
Resident
drop-down
list that corresponds to the completed programming worksheet.
5. Click
Accept
.
6. Repeat for each additional pendant transmitter.
7. When all updates have been made, select
File>Commit Configuration to System.
Assign Transmitters to Stationary Locations in the Event Monitor
For all devices besides pendant transmitters, follow the steps below to add location
information to the transmitter.
1. Click on the
Registers
button in the lower right hand corner of the Event Monitor.
2. Choose
Transmitters
from the page selection pane, and select the transmitter to
be assigned to a location from the list of all transmitters. Refer to the completed
programming worksheet for the correct
Dev#
of the transmitter to be edited.
3. Click
Edit
to unlock the transmitter settings for editing.
4. If a
SF559 Two Button Pull-Cord
station is being edited, choose the
Used As
setting from the drop-down menu that corresponds to the insert placed in the
IL948 Tek-CARE
®
500 & Tek-CARE
®
550 Installation Manual • 35
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
