Tecnoalarm TP8-64, Руководство пользователя

Страница: 38 / 76

Programming User Manual - TP8-64
3-12
3.9.2 ASSOCIATION BUTTONS
Permits the association of the following functions to the 3 function keys
Submenus
z
Disarming (of all the programs that have previously been armed by the
z
Arm. program (a determined program from 1 to 8)
z
Dis. program (a determined program from 1 to 8)
z
ON/OFF rem ctrl (a determined remote control from 1 to 8)
z
ON rem ctrl (a determined remote control from 1 to 8)
z
OFF rem ctrl (a determined remote control from 1 to 8)
3.9.3 ATTRIBUTS
Submenus
z
By-pass
Defines whether the wireless keys is to be used for arming and disarming or
activation and deactivation of by-pass. If the attribute is selected, the function of the
arming and disarming keys change as follows:
„
Arm. program becomes activation of by-pass of the program
„
Dis. program becomes deactivation of by-pass of the program
„
Disarming becomes general deactivation of by-pass
z
Conf. dis (confirmation of disarming)
If the attribute is selected, disarming by wireless key releases a hold-up alarm
unless it is confirmed by entering a valid code within the delay programmed (see
programming of time parameters). If the code is entered either not at all or late, a
silent hold-up alarm is released and the outputs programmed are activated.
z
Autom. abort (automatic communicator block on disarming)
If the attribute is selected, upon disarming by wireless key all the active telephone
channels as well as those waiting to be activated are blocked.
z
Byp gen. al. (by-pass general alarms)
Permits the by-pass of the general alarms, i.e. arming in the presence of one of the
following alarm conditions: tamper, low battery, power failure, supervision, trouble
module.
z
Duress
Enables the release of a panic alarm by pressing the keys 2 and 3 of the wireless
key simultaneously.
z
Excl. disab.
Disables both the voluntary exclusion of zones and the automatic exclusion of
open zones. If the control panel is armed in the presence of open zones, these
will release an alarm at the end of the arming phase.
Commands available
+
#
YES to associate the function to the wireless key
+
*
NO to cancel an existing association
+
EXIT to confirm and quit
Viewing of the current settings
[ ] Attribute has not been associated to the wireless key selected
[ # ] Attribute has been associated to the wireless key selected
3.9.4 LEARNING
Every wireless key before use must be associated to the control panel. This process
consisting in the storage of the device ID code is commonly called learning.
Viewing of the current settings
[ ] Wireless key has not yet been learnt
[ # ] Wireless key has been learnt
Deletion of an existing wireless key
To delete an existing association, press the star key (
*
No ).
Learning
While on the display is viewed Learn. Waiting (the system is ready for learning), press
the button 1 for at least 10 seconds to initiate the process.
During this period of time, the device transmits its ID code to the control panel.
After learning, on the display is viewed
Learn. Completed .
Learn.
Waiting
Learn.
Completed
WL key 01
Learn.
[ ]