Tecnoalarm TP8-64, Руководство пользователя

Страница: 12 / 76

General Features User Manual - TP8-64
1-2
1.1.2 STANDARD USER MENU
The standard user codes (1...62) do not permit programming but merely:
z
Remote control (activation/deactivation of 1...8 devices)
z
Arming/disarming of the programs 1...8
z
Total disarming (disarming of all programs)
z
Partial disarming (disarming of some of the programs armed)
z
Quick arming/disarming (using the keys
#
and
*
)
z
Viewing of the contents of the event buffer
z
Erasement of the events stored
z
Communicator block (interruption of the active telephone calls)
1.2 ELECTRONIC KEYS
The electronic keys permits:
z
Arming
z
Disarming
z
By-pass
1.3 CONTROL BY TELEPHONE
Some operations can be executed via telephone line using the user codes (master or standard user codes):
z
System status check (the control panel signals if alarms have occurred).
z
Program status check (the control panel signals program status (stand-by/in alarm) and possible alarms that have
occurred) and arming/disarming of the programs.
After arming/disarming, the program status (stand-by/alarm) and possible alarms that have occurred are signaled
again.
z
Check of the remote control output status (on/off) and remote activation/deactivation of max. 8 devices.
After remote activation/deactivation, the status of the remote control outputs is signaled again (on/off).
z
Remote digital verification
The RDV detectors are doppler detectors supplying a sound signal proportionate to the movement detected inside
the protected area. The RDV detectors are activated for approx. 30s.
z
Recording of the opening message
Master code required.
It is possible to record a 10s-message which is played every time the control panel executes an alarm call preceding
the alarm message.
1.3.1 SKIP ANSWERING MACHINE
The control panel may be connected toghether with other devices such as answering machines to the same telephone
line, which answer incoming calls with higher priority. In this case, it is possible to program the skip answering machine
function.
The skip answering machine function is enabled by programming 17 rings.
Set the priority of the answering machine at more than 3 to 5 rings.
When call the control panel, procede as follows:
-
Dial the number and replace the receiver after the first ring
- Call again after 6 but no later than 60 seconds from the first call.
If the control panel receives the second call within 6 to 60 seconds from the first one, that has been interrupted after the
first ring, it answers immediately.
WARNING
Every code arms/disarms merely those programs it has been enabled for.
WARNING
Every code arms/disarms merely those programs it has been enabled for.