Technogym RUN 600 XTPRO, Руководство по техническому обслуживанию

Страница: 131 / 158

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 9.5
9.3.2. H
OURS OF USE OF THE BELT MOTOR
The number of hours the belt motor has been operating:
HOURS MOTOR = xxx
Press
ENTER to go ahead.
9.3.3. M
INUTES OF USE OF THE EVELATION MOTOR
The number of minutes the elevation motor has been operating:
MIN. UP/DOWN = xxx
Press
ENTER to go ahead.
9.3.4. D
ISTANCE COVERED
The distance in Km covered by the belt:
KM DONE = xxx
Press
ENTER to go ahead.
The equipment will now return to the standby mode.
9.4. CHANGING THE MAINTENANCE INFORMATION
To set the maintenance information at the desired values (for example after replacing the CPU
board), with the equipment in the standby mode, press number keys
314 at the same time. The
following message will appear on the matrix display:
PASSWORD = 0
Enter code
2709 (password) and press ENTER to confirm. At this point, the LED matrix will show
the values you can change.
9.4.1. H
OURS ON
To change this value, when the value actually in memory will scroll on the LED matrix:
HOURS ON = xxx
input the desired value using the numeric keys to enter and press
ENTER to confirm. Just press
ENTER to maintain the original value.
9.4.2. H
OURS OF USE OF THE BELT MOTOR
To change this value, when the value actually in memory will scroll on the LED matrix:
HOURS MOTOR = xxx