Page 25 of 52
THIS MANUAL IS THE PROPERTY OF
TECHNOGEL SpA
–
ALL REPRODUCTIONS, EVEN PARTIAL, ARE FORBIDDEN
25
4.2
INTENDED AND NON-INTENDED USES
4.2.1
Intended use
The machine is designed and built to pasteurise the bases for ice cream within the limits reported in
paragraphs 2.1 "Technical features", 2.3 "Features of treated product" and 2.5 "Admitted environmental
conditions".
The operator must apply the correct hygiene procedures for transforming the product, in compliance with the
legislation in force.
4.2.2
Non-intended use
The machine must not be used for different purposes to those intended and specified in paragraph 4.2.1
"Intended use". A different use to that for which the machine was designed may cause a danger for the
operators/maintenance technicians, for the product consumers, for any exposed people and for the machine
itself.
ATTENTION
The machine is not designed to work in potentially explosive atmosphere, its use and
installation in said environments is, therefore, absolutely forbidden.
ATTENTION
A different use to that stated in this manual is considered improper and, therefore,
forbidden. TECHNOGEL SpA declines any liability for a different use of the machine to that
stated in this manual.
4.3
WORK AREAS AND DANGEROUS AREAS
NOTE!
The following definitions are disclosed, in accordance with Directive 2006/42/EC:
• DANGEROUS AREA: any area inside and/or near the machine where the presence of an
exposed person constitutes a health and safety risk for that person.
• EXPOSED PERSON: any person fully or in part inside a dangerous area.
• OPERATOR: the person or people in charge with installing, working, adjusting, cleaning,
repairing and moving the machine or with servicing it.
ATTENTION
The machine must only be controlled and normally run in the areas set-up for its running.
These areas are without risks for the personnel in charge of running and are called
"Operator control and command areas".
ATTENTION
It is forbidden for anyone to move or intervene inside the dangerous areas during machine
running. Maintenance personnel can work around and inside the machine only after having
stopped its functioning and having placed it in safe conditions.
