>
Screw the two stand screws back in, then snap the two previously removed plastic
caps back onto the screw holes.
If you want to reattach the stand, proceed in the reverse order.
2.4.2 Mounting the wall bracket
>
Loosen and remove the four marked screws.
>
Now proceed as described in the wall bracket assembly instructions to attach it to the
TV.
>
Use the threaded sleeves into which the four screws you removed were inserted to
screw the wall bracket onto the TV.
In doing so, please ensure that the screws are not allowed to be screwed deeper than
20 mm into the TV.
2.5 Remote control
2.5.1 Changing the battery
>
Open the cover of the battery compartment at the rear of the remote control by
pushing it in the direction of the arrow and then lifting it off.
>
Insert the supplied batteries, ensuring that the poles are the right way around
(indicator visible in battery compartment).
>
Close the battery compartment again.
2.5.2 Remote control code
By switching over the remote control option it is possible to use this remote control to
operate a TechniSat television and two TechniSat receivers using the same coding.
>
Hold down the
remote control code
button to switch over the remote control
option and press the
OK
button as often as necessary until the LED for the desired
remote control option (
TV
,
SAT1
or
SAT2
) flashes briefly.
The currently set remote control code will be displayed, as the appropriate LED
flashes, while pressing a button.
8
