ጝሁႠీ!ਝൽጆॆ
15
4).Operating modes:
(AUTO): AUTO MODE;
(CENTER): CENTER MODE;
(MANUAL): MANUAL MODE.
The parameters of AWG5000 control enclosure are described below:
0).Web compensation enable bit.
Parameter code number:00
The default setting is for Web Guiding Control.
Note that the display screen will show “00-00” immediately
after power is turned on and after the
SETUP
button is
pressed, now the system enters into the parameter setting
course;
(The front two digits of ’00-00’ means the parameter code
number, the later two digits means data value corresponding
to the parameter code number.);
Press the
OUT
or
IN
buttons so that you could select the
parameter you want to examine and/ or adjust. Each param-
eter has a unique code number.;
Press
SETUP
button to activate configure of a certain pa-
rameter code number;
Press the
OUT
or
IN
buttons to adjust the parameter value;
Press
SETUP
to store the new data value in non-volatile
memory;
To leave the data value at its original value press
ESC
;
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
Содержание AWG5000
