Techmach AWG5000, Руководство по эксплуатации

Страница: 19 / 32

ጝሁႠీ!ਝൽጆॆ
17
7).Manual Polarity
Parameter code number: 07
Parameter range: [0, 1], the default value is 0
0 — The actuator extends when the OUT mode is selected, and retracts when the IN mode is select
1 — The actuator extends when the IN mode is selected, and retracts when the OUT mode is selected
8).Power-up Mode
Parameter code number: 08
Data: [0-2], the default value is 0
0 — The system will power-up in Manual mode
1 — The system will power-up in Servo-Center mode
2 — The system will power-up in the same operating mode that was selected when last powered-down
9).Edge-Loss and Line-Loss Detection
Parameter Code number: 09
Data: [0, 1], the default value is 0
0 — Edge-Loss and Line-Loss detection are disabled
1 – Edge-Loss and Line-Loss detection are enabled
10).Sensor operation mode
Parameter Code number: 10
Parameter range: [0-3], the default value is 0
0 – Sensor on the mode of edge
11).Sensor’s regular interval
Parameter code number: 11
Parameter Range: [4-20], the unit is ms, the default value is 4ms
This parameter determines the sensor’s regular interval.
12).compensate time
Parameter code number: 12
Parameter range: [ 0-20], the default value is 0
This parameter is typically used to adjust the compensate time for edge defect, and the motor drive is turned off during
this compensate time, the motor drive is turned on after this compensation. Make sure Parameter 9 ( Edge-Loss and
Line-Loss Detection ) to be configured before enable this parameter.