6-12
EO18-33003A
6. DIAG. TEST OPERATION
■
Parameter Setting Mode Table
6.3 PARAMETER SETTING MODE
Mode Name
FEED ADJ.
CUT ADJ.
BACK ADJ.
X ADJUST
TONE ADJ. <T>
TONE ADJ. <D>
FONT CODE
ZERO FONT
XON+READY
CODE
RIBBON ADJ. <F>
RIBBON ADJ. <B>
STATUS TYPE
THRESHOLD R
THRESHOLD T
KANJI CODE
FEED SPEED
EURO CODE
5CH CHR
Function
Using this parameter the feed length is fine adjusted.
Using this parameter the cut position or strip position is fine adjusted.
Using this parameter the back feed length from the cut/strip position
to the home position is fine adjusted.
This setting is used to finely adjust print position in the X axis.
Using this parameter the print tone is fine adjusted at the thermal transfer
printing. The longer the print pulse width, the darker the print tone
becomes. The shorter, the lighter the print tone becomes.
Using this parameter the print tone is fine adjusted at the thermal direct
printing. The longer the print pulse width, the darker the print tone
becomes. The shorter, the lighter the print tone becomes.
The character code is selected from.
PC-8, PC-850, PC-851, PC-852, PC-855, PC-857, PC-1250, PC-1251,
PC-1252, PC-1253, PC-1254, PC-1257, ARABIC, LATAIN9
The font zero either 0 or ø is selected.
Transmission control mode of the serial interface is selected.
The command code out of AUTO, ESC/LF/NUL, or { } is selected.
Using this parameter the ribbon motor voltage (take-up side) is fine
adjusted.
Using this parameter the ribbon motor voltage (feed side) is fine
adjusted.
Whether or not the strip wait status (05H) is sent in response to the
status request command from the PC is selectable.
The threshold of the black mark sensor is manually fine adjusted.
The threshold of the feed gap sensor is manually fine adjusted.
Unavailable
Feed speed is adjusted to prevent shrunk printing.
The EURO font code is selected.
Character Code 5CH is set to ¥ (YEN) or \ (back slash)
