3-16
EO18-33003A
3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
3.7.2 Installation Procedure
1) Turn the power off.
2) Open the top cover and remove the two PT-3x10 screws. (Refer to Section 3.1.)
3) Disconnect the KEY LED harness from CN14 on the CPU PC board to detach the side cover L.
(Refer to section 3.1.)
4) Remove the PT-3x10 screw to detach the side cover R. (Refer to section 2.3.)
5) Attach the enclosed cable clamps MSC-1 and DKN-5 as shown below.
(Revision Date: Jan. 23, 2001)
3.7 STRIP MODULE (B-7904-H-QM)
6) For TS Model
Open the print head block, and then detach the paper guide base.
Fig. 3-32
Fig. 3-33
Cable Clamp MSC-1
Cable Clamp DKN-5
Print Head Block
About 2 mm
About 22 mm
About 85 mm
Paper Guide Base
