83-517-000 Rev.
A
25
1
R
e
m
o
t
e
(
+
)
s
e
n
s
e
2
L
o
c
a
l
(
+
)
s
e
n
s
e
3
N
o
t
c
o
n
n
e
c
t
e
d
4
L
o
c
a
l
(
-
)
s
e
n
s
e
5
R
e
m
o
t
e
(
-
)
s
e
n
s
e
Figure 3-2: Stripped Wires installed in Strain Relief
4. Route the AC wires to the input connector terminals as required. To connect the wires, loosen the terminal
screw, insert the stripped wire into the terminal and tighten the screw securely (4.4~5.3 lb-inch/0.50
– 0.60
Nm).
5. Route the wires inside the cover to prevent pinching. Fasten the cover to the unit using the M3x8 flat head
screws which are provided. Strain relief cover could be opened for inspection. Refer to Figure 3-3 for details.
Figure 3-3: AC Input Cover and Strain Relief, 2400W models
3.8
TURN-ON CHECKOUT PROCEDURE
General
3.8.1
The following procedure ensures that the power supply is operational and may be used as a basic incoming
inspection check. Refer to Figure 4-1 and Figure 4-2 for the location of the controls indicated in the procedure.
Prior to Operation
3.8.2
1. Ensure that the power supply is configured to the default setting:
-
Front panel AC On/Off switch at the
OFF
position.
-
SW1 DIP-switch: All positions at the
DOWN
(“Off”) position.
-
J2 Sense connector: Configured to Local Sense as shown in Figure 3-4:
Plug P/N: MC1.5/5-ST-3.81
(Phoenix)
Figure 3-4: Sense Connector, Default Connection
-
For units equipped with the LAN (or IEEE option), ensure that the LAN_En (or IEEE_En) switch is
in the
UP
position (refer to Figure 4-2, Item 8 for location). For units with the USB option, ensure
that the USB_En switch is in the
DOWN
position.
Fig.3-2: Stripped Wires installed in Strain Relief
Screw-on
Locknut
1.
Remote (+) sense
2.
Local (+) sense
3.
Not Connected
4.
Local (-) sense
5.
Remote (-) sense
Содержание GENESYS GEN 2400W Series
