TDK-Lambda GENESYS GEN 2400W Series, Техническое руководство

Страница: 32 / 88

83-517-000 Rev. A
22
WARNING
The Genesys
TM
series is intended only for installation in Restricted Access
Location (RAL). Access to Hazardous parts (rear side of the power supply)
shall be prevented after installation.
NOTE
Genesys
TM
power supplies generate magnetic fields, which might affect the
operation of other instruments. If your equipment is susceptible to magnetic
fields, do not position it adjacent to the power supply.
WARNING
To avoid electric shock hazard, do not insert conductive parts through the
front panel slits.
CHAPTER 3 INSTALLATION
3.1 GENERAL
This Chapter contains instructions for initial inspection, preparation for use and repackaging for shipment.
Connection to PC, setting the communication port and linking Genesys
TM
power supplies are described in
Chapter 7.
3.2 PREPARATION FOR USE
In order to be operational the power supply must be connected to an appropriate AC source. The AC source
voltage should be within the power supply specification. Do not apply power before reading Section 3.6 and 3.7.
Table 3-1 below, describes the basic setup procedure. Follow the instructions in Table 3-1 in the sequence given
to prepare the power supply for use.
Step # Item Description Reference
1
Inspection Initial physical inspection of the power supply Section 3.3
2 Installation
Installing the power supply,
Ensuring adequate ventilation. Section 3.4
Section 3.5
3
AC source
AC source requirements
Connecting the power supply to the AC source Section 3.6
Section 3.7
4 Test Turn-on checkout procedure. Section 3.8
5 Load connection
Wire size selection. Local/Remote sensing. Single
or multiple loads.
Section 3.9
6 Default setting The power supply setting at shipment. Section 7.2.1
Table 3-1: Basic Setup Procedure
3.3 INITIAL INSPECTION
Prior to shipment this power supply was inspected and found free of mechanical or electrical defects. Upon
unpacking of the power supply, inspect for any damage, which may have occurred in transit.
The inspection should confirm that there is no exterior damage to the power supply such as broken knobs or
connectors and that the front panel and meter’s faces are not scratched or cracked. Keep all packing material
until the inspection has been completed. If damage is detected, file a claim with carrier immediately and notify
the TDK Lambda Americas, Inc. Sales or Authorized Service Facility near you.
3.4 RACK MOUNTING
The Genesys
TM
power supply series is designed to fit in a standard 19” equipment rack.
To Install the Power Supply in a Rack: 3.4.1
1. Use the front panel rack-mount brackets to install the power supply in the rack.
2. Use a support bar to provide adequate support for the rear of the power supply. Do not obstruct the air
exhaust at the rear panel of the unit.