Taylor-Dunn G0-010-00, Инструкция по обслуживанию и замене запасных частей

Страница: 140 / 362

3.80
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
CRANKCASE BREATHER VALVE / HOSE
The breather valve is on the hose that runs between the
engine and air box. Be sure breather line is routed
properly and secured in place.
NOTICE
Notice the hose adapter used in the engine breather
hose assembly.
1. Remove the left side panel
2. Remove the hose clamps from the valve and pull the
valve out of the hoses.
3. Inspect the valve for debris. Blow gently through the
valve to check for clogging. Replace a damaged or
clogged valve.
4. Check the hoses for cracks, deterioration, abrasion,
or leaks. Replace as needed.
CAUTION
Make sure lines are not kinked or pinched.
5. Reinstall the valve and hose clamps.
CAUTION
Operation of your vehicle without a breather valve can
cause engine damage. Always reinstall the breather
valve after removing it for service.
6. Install the left side panel
CRANKCASE SEPARATION
NOTICE
Before the crankcase can be separated, be sure the
entire top end, water pump stator, flywheel and oil
pump assembly are removed from the engine as
outlined in this chapter.
1. Remove the engine from the engine stand and lay it
on a table so the magneto side is facing upward.
WARNING
Support the engine case with a non marring material to
prevent damaging the PTO side of the crank shaft and
any mating surfaces.
Ensure the crank case is stable before working on it.
2. Remove the oil pan at this time if it has not already
been removed.
3. Remove the oil filter and the fasteners
q
that secure
oil filter adapter
w
to the crankcase. Discard O-rings
and thoroughly clean the adaptor for reassembly.
4. Remove and discard the flange bolts
e
fastening the
intermediate (mag) cover
r
evenly in a criss-cross
pattern.
ENGINE / COOLING SYSTEM