Taylor-Dunn G0-010-00, Инструкция по обслуживанию и замене запасных частей

Страница: 179 / 362

4
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
4.31
15. Reinstall the fuel line to the fuel rail.
16. Connect the harness lead to the fuel injector.
17. Reconnect the negative battery cable and reinstall
the driver’s seat.
18. Cycle key ON several times to pressurize the fuel
system, and inspect the fuel rail and injector for fuel
leaks.
FUEL INJECTOR TROUBLESHOOTING
Injector problems typically fall into three general
categories- electrical, dirty / clogged, or leakage. An
electrical problem usually causes injectors to stop
functioning. Several methods may be used to check if the
injector is operating.
• With the engine running at idle, feel for operational
vibration, indicating that they are opening and closing.
• When temperatures prohibit touching, listen for a
buzzing or clicking sound with a screwdriver or
mechanic's stethoscope.
NOTE
Do not apply voltage directly to the fuel injector.
Excessive voltage will burn out the injector. Do not
ground the injector with the ignition on. The fuel injector
will open/turn on if relay is energized.
If an injector is not operating, it can indicate either a bad
injector, or a wiring/electrical connection problem. Check
as follows:
Injector leakage is very unlikely, but in rare instances it
can be internal (past the tip of the valve needle), or
external (weeping around the injector body). The loss of
system pressure from the leakage can cause hot restart
problems and longer cranking times.
Injector problems due to dirt or clogging are unlikely due
to the design of the injectors, the high fuel pressure, the
use of filters and the detergent additives in the gasoline.
Symptoms that could be caused by dirty/clogged
injectors include rough idle, hesitation/stumble during
acceleration, or triggering of fault codes related to fuel
delivery. Injector clogging is usually caused by a buildup
of deposits on the director plate, restricting the flow of
fuel, resulting in a poor spray pattern. Some contributing
factors to injector clogging include; dirty air filters, higher
than normal operating temperatures, short operating
intervals and dirty, incorrect, or poor quality fuel.
Cleaning of clogged injectors is not recommended; they
should be replaced. Additives and higher grades of fuel
can be used as a preventative measure if clogging has
been a problem.
FUEL SYSTEM