Taylor-Dunn G0-010-00, Инструкция по обслуживанию и замене запасных частей

Страница: 50 / 362

2.26
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
STEERING
STEERING INSPECTION NOTE
The steering components should be checked periodically
for loose fasteners, worn tie rod ends, and damage. Also
check to make sure all cotter pins are in place. If cotter
pins are removed, they must not be re-used. Always use
new cotter pins.
Replace any worn or damaged steering components.
Steering should move freely through entire range of
travel without binding. Check routing of all cables, hoses,
and wiring to be sure the steering mechanism is not
restricted or limited.
NOTE
Whenever steering components are replaced, check
front end alignment. Use only genuine TAYLOR-DUNN
parts.
WARNING
Due to the critical nature of the procedures outlined in
this chapter, TAYLOR-DUNN recommends steering
component repair and adjustment be performed by an
authorized technician when replacing worn or damaged
steering parts.
Use only genuine TAYLOR-DUNN replacement parts.
TIE ROD END / STEERING INSPECTION
• To check for play in the tie rod end, grasp the steering
tie rod, pull in all directions feeling for movement.
• Replace any worn steering components. Steering
should move freely through entire range of travel
without binding.
Elevate front end of machine so front wheels are off
the ground. Check for any looseness in front hub/
wheel assembly by grasping the tire firmly at top and
bottom first, and then at front and rear. Try to move the
wheel and hub by pushing inward and pulling outward.
• If abnormal movement is detected, inspect the hub and
wheel assembly to determine the cause (loose wheel
nuts or loose front hub nut).
• Refer to the Steering/Suspension or Final Drive
chapter for more information.
MAINTENANCE