Taylor-Dunn G0-010-00, Инструкция по обслуживанию и замене запасных частей

Страница: 303 / 362

9
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
9.15
2. Inspect piston for nicks, scratches, wear or damage.
Measure diameter and replace if damaged or worn
beyond service limit.
MEASUREMENT
Front Caliper Piston O.D.:
Std. 1.4985-1.5000” (38.062 - 38.10 mm)
Service Limit 1.4980” (38.049 mm)
3. Inspect the brake disc and pads as outlined for brake
pad replacement in this chapter.
FRONT CALIPER ASSEMBLY
1. Install new square O-rings
q
in the caliper body. Be
sure that the grooves are clean and free of residue or
brakes may drag.
2. Coat the piston with clean DOT 4 Brake Fluid (P/N
2872189). Install piston
w
with a twisting motion
while pushing inward. Piston should slide in and out
of bore smoothly, with light resistance.
3. Lubricate the mounting bracket pins with disc brake
caliper lube, and install the rubber dust seal boots.
CAUTION
Do not allow grease to come into contact with the piston
and seals.
Damage may occur to the components.
4. Compress the mounting bracket and make sure the
dust seals are fully seated. Install the brake pads.
Clean the disc and pads with brake parts cleaner or
denatured alcohol to remove any dirt, oil or grease.
FRONT CALIPER INSTALLATION
1. Install caliper on hub strut, and torque mounting bolts
q
.
TORQUE
Front Caliper Mounting Bolt:
46 ft-lbs (62 Nm)
2. Install brake line and tighten securely with a flare nut
wrench.
BRAKE SYSTEM