Taylor-Dunn G0-010-00, Инструкция по обслуживанию и замене запасных частей

Страница: 38 / 362

2.14
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
COOLING SYSTEM
COOLING SYSTEM OVERVIEW
The engine coolant level is controlled, or maintained, by
the recovery system. The recovery system components
are the recovery bottle, radiator filler neck, radiator
pressure cap and connecting hose.
As coolant operating temperature increases, the
expanding (heated) excess coolant is forced out of the
radiator past the pressure cap and into the recovery
bottle. As engine coolant temperature decreases the
contracting (cooled) coolant is drawn back up from the
bottle, past the pressure cap, and into the radiator.
NOTE
Some coolant level drop on new vehicles is normal as
the system is purging itself of trapped air. Observe
coolant level often during break-in period.
CAUTION
Overheating of engine could occur if air is not fully
purged from system.
TAYLOR-DUNN recommends the use of 50/50 Extended
Life Antifreeze or a 50/50 mixture of high quality
aluminum compatible anti-freeze/coolant and distilled
water.
NOTE
50/50 Extended Life Antifreeze is already premixed and
ready to use. Do not dilute with water.
COOLANT LEVEL INSPECTION
The recovery bottle
q
and radiator pressure cap
w
are
located under the hood.
With the engine at operating temperature, the coolant
level should be between the “MAX” and “MIN” marks on
the recovery bottle. If not, perform the following:
1. Position the vehicle on a level surface.
2. The coolant level must be maintained between the
“MAX” and “MIN” levels indicated on the recovery
bottle.
3. If the coolant level is below the “MIN” mark, open the
hood to access the radiator pressure cap and
recovery bottle cap.
NOTE
If overheating is evident, allow system to cool
completely and check coolant level in the radiator and
inspect for signs of trapped air in system.
WARNING
Never remove the pressure cap when the engine is
warm or hot. Escaping steam can cause severe burns.
The engine must be cool before removing the pressure
cap.
4. Remove the pressure cap. Using a funnel, add
coolant to the top of the radiator filler neck.
5. Reinstall the pressure cap.
NOTE
Use of a non-standard pressure cap will not allow the
recovery system to function properly.
6. Remove the recovery bottle cap.
7. Fill the recovery bottle to the “MAX” mark with
Premium 50/50 Anti-Freeze/Coolant or a 50/50
mixture of antifreeze/coolant and distilled water as
required for freeze protection in your area.
8. Reinstall the recovery bottle cap.
MAINTENANCE