Taylor-Dunn G0-010-00, Инструкция по обслуживанию и замене запасных частей

Страница: 249 / 362

6
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
6.25
9. Using a 5 mm Allen wrench, install only the (3)
screws that secure the pinion shaft assembly as
shown below. Leave the longer locking screw (A) out
at this point.
NOTICE
DO NOT install the longer screw (A). Installing the
longer screw will lock the snorkel tube and not allow for
backlash setting adjustment.
10. Torque the bearing cover retaining screws to
specification.
TORQUE
Snorkel Bearing Cover Retaining Screws:
8 ft-lbs (11 Nm)
11. Rotate the snorkel tube counterclockwise using the
snorkel tool (PA-50231) until the snorkel gear and
pinion gear have ‘zero’ backlash.
NOTICE
DO NOT overtighten the snorkel tube when backing it
out. At the 'zero' backlash position, you should still be
able to turn the snorkel shaft using your fingers, but it
will feel rough and may have some tight spots.
12. Look down into the transmission housing to see the
snorkel locking screw hole opening to reference your
starting point.
NOTICE
If you have a hard time seeing into the hole, insert a
small Allen wrench, punch or screwdriver into the hole
to feel when the notch is aligned with the hole.
13. Slowly rotate the snorkel tube clockwise while
counting the number of notches passing through the
hole opening as you rotate the tube. Rotate the
snorkel tube to the
3rd notch from the ‘zero’
backlash position obtained in step 11.
14. Check the pinion shaft gear backlash again by feel. If
the pinion shaft gear lash appears to be too tight,
rotate the snorkel shaft
clockwise to the next notch
(4th notch).
15. Once the backlash is set, apply Loctite ® 242™ to the
threads and install the locking screw to secure the
snorkel tube.
TRANSMISSION