tatsuno OCEAN TOWER Series, Инструкция по установке и эксплуатации

Страница: 160 / 173

TATSUNO EUROPE a.s., www.tatsuno ‐ europe.com
160
The special PDEX5 counter mode is used (M6 ‐ P09) for automatic electronic calibration of the meter , in
which the correction factor of the meter is automatically calculated and set. In this way, it is also possible
to calibrate dispenser with active temperature compensation of the volume.
The automatic meter calibration mode is activated by parameter M6 ‐ P15.
NOTE
For dispensers with ultra ‐ high filling (130 L/min), where two meters are used for one dispensing hose /
nozzle, it is necessary to first calibrate the main meter when setting parameter M6 ‐ P15 = 1. The counter does
not start the auxiliary pump motor when calibrating the main meter. After calibration of the main meter, the
auxiliary meter is calibrated when parameter M6 ‐ P15 = 2 is set. The counter does not start the main pump
motor when calibrating the auxiliary meter.
The procedure for automatic electronic calibration of the meter is as follows:
1) The PDEX5 counter processor unit cover is de ‐ sealed, removed and switch SW1 ‐ 1 is switched to
the OFF position.
2) Using the PDERT ‐ xS service remote controller after entering the service
password, the service level of the counter configuration is entered and the
parameter value in M6 ‐ P15 is changed to 1 or 2, thus activating the
automatic meter calibration mode.
3) Accurate delivery into the calibrated
vessel is performed. The vessel volume
must be 10L, 20L, 50L, or 100L.
4) After hanging the nozzle, "E ‐ C" appears
on the bottom line of the display and the
counter waits for confirmation whether
it should consider the performed
measurement valid and should calculate
a new correction factor.
5) After pressing the <E> key, a new
correction factor is calculated and saved automatically.
6) A new accurate delivery into the
calibrated vessel is performed.
7) If equality is not achieved between the volume in the vessel and the
indicated volume, the calibration can be repeated according to point 4).
8) If everything is OK, the switch back to the standard operating mode is
performed by setting parameter M6 ‐ P15 to the value 0.
9) Switch SW1 ‐ 1 is switched to the ON position, the processor unit is covered with a cover and
sealed.
10000
20087
F 384
current correction factor (1.0000)
volume (20.087L)
current flowrate (38.4 l/min)
10000
20087
E ‐ C
current correction factor (1.0000)
volume (20.087 L)
E ‐ confirm/ C ‐ cancel
9957
20087
new value of the corr. factor 0.9957)
volume (20.087 L)
9957
20000
E ‐ C
current correction factor (0.9957)
volume (20.000L)
E – confirm / C ‐ cancel
M6
1
P15
M6
0
P15