TATA Motors Nexon EV 2003, Руководство пользователя, Страница: 78 / 308

level
If SOC of source vehicle reaches the
10.
agreed Limit and to stop the V2V
charging from source vehicle side,
press the V2X switch of source vehicle
to disable the 220V AC supply and fol-
low from step 14 after 5sec
If Sink vehicle is charged up to the
11.
agreed SOC level and to stop the V2V
charging from sink vehicle side, press
its fascia switch to stop charging and
then ensure to press the V2X switch of
source vehicle to stop the AC power
supply. & follow step 12
After 5 sec delay press source vehicle
12.
fascia switch and then remove both the
guns & follow step 15
In case V2V charging gets interrupted
13.
from source/sink vehicle side due to
any fault, Press the Gun unlock fascia
switch in both vehicle and completely
remove the gun from both side while
keeping the vehicles in Ignition ON and
repeat from step 1. If the issue still re-
mains, Press the Gun unlock fascia
switch in both vehicle and completely
remove the gun from both side both.
After that both vehicle should brought
in to ignition OFF state. Keep the vehi-
cles in Ignition OFF state for 30sec.
Then repeat from Step 1. If the charg-
ing get interrupted again from vehicle
side go to step 14 to 15 and contact
service station.
To remove the gun, Press Fascia
14.
switch of both vehicles. Close the V2V
adaptor caps to ensure that it is not ex-
posed to mud/metal particle etc.
Turn off the Ignition in both vehicles
15.
DON’T’S
Don’t switch off the Ignition in source 1.
or sink vehicle during V2V charging
Don’t crank source or sink vehicle dur-
2.
ing V2V charging
Don’t use un authorized V2V gun
3.
Don’t press the V2X switch of sink ve- 4.
hicle throughout the sink vehicle
charging
Don’t keep the V2V charging gun open
5.
at sink vehicle side while pressing the
v2x switch in the source vehicle after
connecting the source side gun.
Don’t perform V2V charging in other
6.
vehicles which is not recommended by
the TPEM ( list to be published later)
as source and sink vehicle
Don’t keep the V2V gun caps open
7.
after the use to ensure it is not ex-
posed to mud/metal particle etc.
Don’t start V2V charging function if
8.
source Vehicle SOC is lesser than or
equal to 30%.
Do not perform V2V charging during
9.
rain or in any situation where it might
be exposed to water
Don’t press V2X switch and fascia
10.
switch together to stop the
function(keep minimum 5sec delay )
Don’t keep both vehicle at far distance
11.
where the gun has to stretch maximum
to connect between the vehicles.
Don’t disengage the park brake in ei-
12.
ther of the vehicles during the charg-
ing.
Don’t insert the V2L connector when
13.
vehicle is in Crank or EV ready condi-
CHARGING
69