TATA Motors Nexon EV 2003, Руководство пользователя, Страница: 234 / 308

How To Proceed In The Event Of A
Tire Puncture
First pump the tire sealant and air into the
tire (see Step 1).Immediately there-after,
drive a short distance (3-10 km) in order to
distribute the seal-ant in the tire. After that
check the tire pressure and pump more air
into the tire if necessary (see Step 2).
Then you can proceed to drive with cau-
tion for a maximum distance of 200 kms
and at a maximum speed of 80 km/h. First
pump the tire sealant and air into the tire
(see Step 1).Immediately there-after, drive
a short distance (3-10 km) in order to dis-
tribute the seal-ant in the tire. After that
check the tire pressure and pump more air
into the tire if necessary (see Step 2).
Then you can proceed to drive with cau-
tion for a maximum distance of 200 kms
and at a maximum speed of 80 km/h.
Step 1
Take out the hose and power plug with 1.
cable out of the tyre puncture repair kit
casing. Remove the white cap of T-
type connector of Sealant Bottle.
Connect the hose pipe of the compres-
2.
sor with T-type connector of sealant
bottle. Ensure it is tightly Fitted.
Avoid skin contact with the sealant
3.
which contains natural rubber latex. Do
not open pressure “air release” valve.
Use enclosed protective gloves.
Install sealant Bottle by rotating clock-
4.
wise firmly against the bottle holding
grooves on the compressor. Remove
the white cap of the hose pipe of the
sealant bottle
.
Insert power plug into the 12 volt 5.
power socket connection.
Start the vehicle in idling (only if the ve-
6.
hicle is outdoors or in a well ventilated
area).
Press compressor switch to ON Impor- 7.
tant: When pumping in the sealant
through the tyre valve, the pressure
may rise up to 500 KPa (5 bar. 73 psi)
but will drop again after about 30 sec-
onds
Inflate the tyre to an inflation pressure 8.
of minimum 180kPa, (1.8 bar/26 psi)
and a maximum of 300kPa (3 bar/43
psi).
Remove the sealant bottle from the
9.
compressor grooves & tight the white
caps on the hose pipe of the sealant
bottle as well as T -type connector of
the sealant bottle. This avoids unex-
pected leakage of sealant residue and
Lock it.
Make sure the puncture repair kit
10.
stored safely, but it’s still easily acces-
sible, in the vehicle.
The compressor will be needed again
11.
when you check the tyre pressure.
WARNING
Ensure pump should not be ON for
more than 10 min as it may heat up and
stop working.
EMERGENCY AND BREAKDOWN
225