TATA Motors Nexon EV 2003, Руководство пользователя, Страница: 76 / 308

labels on the V2V gun and make sure
that the V2Vgun side labeled as
“source” should connect to the source
vehicle & the other end labeled as
“sink” should connect to the sink vehi-
cle. If user couldn’t connect the V2V
gun within 120sec of step4. Remove
the Gun completely and repeat from
step 4
Make sure park-brake/EPB is en-
6.
gaged.
Ensure V2V gun is connected to both
7.
vehicles and press the V2X switch of
source vehicle within 120sec of step5
to start the 220V AC power supply and
to charge the sink vehicle. If user
couldn’t press V2X switch within
120sec of successful step 5. Remove
the Gun completely and repeat from
step 4 to initiate the V2V function
again.
Check for the telltale indication fre-
8.
quently when the V2V function is in
progress to ensure there is no interrup-
tion/fault.
V2V function will stop from source ve-
9.
hicle side, if there is no energy dissipa-
tion has happened for 100secs from
successful step 7. In this case, remove
the gun completely and start from step
4 to reinitiate the V2V function
Charging will automatically stop if the
10.
source vehicle SOC goes below the
user set SOC limit or at 30%. In that
case follow the procedure from step
16.
Also monitor the SOC of both vehicles
11.
frequently to check if sink vehicle is
charged enough/ source vehicle SOC
is reached the minimum required SOC
level
To stop the V2V charging from source
12.
vehicle side, press the V2X switch of
source vehicle to disable the 220V AC
supply and follow from step 16 after
5sec
To stop the V2V charging from sink ve-
13.
hicle side, press its fascia switch and
then ensure to press the V2X switch of
source vehicle to stop the AC power
supply. & follow step 14
After 5 sec delay press source vehicle
14.
fascia switch and then remove both the
guns
In case V2V charging gets interrupted
15.
from source/sink vehicle side due to
any fault, Press the Gun unlock fascia
switch in both vehicle and completely
remove the gun from both side and re-
peat from step 4. If the issue still re-
mains, Press the Gun unlock fascia of
both vehicle and completely remove
the gun. After that keep the vehicles in
Ignition OFF state for 120 seconds.
Then repeat from Step 4.If the charg-
ing get interrupted again from vehicle
side go to step 16 and contact nearby
TAT service station
To remove the gun, Press Fascia
16.
switch of both vehicles. Close the V2V
charging gun caps to ensure that it is
not exposed to mud/metal particle etc.
DON’TS
Don’t shift the gear 1.
Don’t crank source or sink vehicle dur- 2.
ing V2V charging
Don’t use un authorized V2V gun
3.
CHARGING
67