TATA Motors Nexon EV 2003, Руководство пользователя, Страница: 242 / 308

Step 2
Once a tyre inflation pressure of at 1.
least 180kPa (1.8 bar/26 psi) has been
reached. Switch the compressor to “0”
in order to read the actual tyre pres-
sure from the pressure gauge.
Pull the power plug from the 12 volt
2.
power socket connection.
Slowly unscrew the hose from the tyre
3.
valve (sealant residues may escape
from the hose) and put the protective
cap back onto the hose.
Leave the bottle in the holder. This
4.
avoids unexpected leakage of sealant
residue.
Make sure the Puncture repair Kit, the
5.
cap of the bottle and the orange cap
are stored safely, but are still easily ac-
cessible, in the vehicle.
The kit will be needed again when you
6.
check the tyre pressure.
Start and drive for about 3-10 km so 7.
that the sealant can seal the damaged
area. Do not drive for more than 10
min and not faster than 80 km/h.
Stop the vehicle after driving about 3-
8.
10 km. Check and where necessary,
adjust the pressure of the damaged
tyre. Remove the protective cap from
the end of the hose. Screw the hose
firmly onto the valve of the damaged
tyre. Read the tyre pressure from the
pressure gauge.
If the pressure of the sealant-filled tyre
9.
is 130kPa (1.3 bar/19 psi) or more, it
must now be adjusted to the pressure
specified for your vehicle (Refer tyre
pressure sticker pasted on driver door
side).
Deflate the tyre to the specified pres-
10.
sure using the pressure “air release”
valve. Rest of the remaining sealant in
the hose might leak out when opening
pressure “air release” valve or taking
off the protective cap of the hose.
Please use protective glove for safety
purpose.
Once you have inflated the tyre to its 11.
correct tyre pressure, switch off the
compressor, pull the plug out of the
socket, unscrew the hose, fasten the
tyre valve cap and put back on the pro-
tective cap of the hose.
Leave the bottle in the holder and store
12.
the Puncture repair Kit away safely in
the vehicle trunk
Drive to the nearest workshop to get
13.
the damaged tyre repaired and if the
tyre repair is not possible it should be
removed from the car. Before the tyre
is removed from the rim, inform your
tyre dealer that the tyre contains
sealant.
WARNING
Need to drain fluid from tyre before re-
pair.
WARNING
If heavy vibrations, unsteady steering
behavior or noises should occur while
driving, reduce your speed and drive
with caution to a place where it is safe
for you to stop the vehicle. Recheck the
tyre and its pressure. If the tyre pres-
sure is less than 130kPa (1.3bar, 19
psi) or if there are any visible cracks,
EMERGENCY AND BREAKDOWN
233