TANDELTA OQSExISG2, Руководство пользователя

Страница: 22 / 130

Page | 20
6.2 Installation
6.2.1 Precautions
Please read these instructions before installing the oil quality sensor. The sensor has been
designed to be robust, however it can be damaged by mistreatment. The following must be
noted:
Install the sensor into the equipment before attempting electrical/wiring connections.
To avoid thread damage, do not use with taper fittings.
Tighten with a correctly adjusted size spanner (32mm) and do not over tighten.
Do not attempt to screw or tighten the sensor using the body. Always use the “Hex”
head with the correct size spanner (32mm).
To prevent vibration having any adverse effects to the cable/sensor connectors, the
cable should either be mounted on the same plane at the sensor, or have a loop fitted
to absorb vibration, as per diagrams below;
Do not twist the cable relative to the sensor head.
Keep away from sharp edges which may cut into the cable.
Do not bend the cable excessively, minimum bend radius = 50mm (2 inches).
Where possible, keep the cable away from sources of heat, (such as an engine block),
and electrical interfaces.
Oil pressure should not exceed 70 bar.
Figure 9 - Cable Fitting