Tandberg Data StorageLibrary T40 T40, Инструкция по установке и эксплуатации

Страница: 77 / 95

StorageLibrary Installation and User Guide 69
RAS
Ticket Display Message Description Suggested Action
6004 Drive n Tape Alert
4. Media The operation has
stopped because an
error has occurred while
reading or writing data.
Your data is at risk:
Copy any data you require from this tape.
Do not use this tape again.
Restart the operation with a different tape.
6005 Drive n Tape Alert
5. Read Failure The tape is damaged or
the drive is faulty.
Clean the drive.
Try another cartridge.
If the problem persists, replace the tape
drive.
6006 Drive n Tape Alert
6. Write Failure The tape is from a faulty
batch or the tape drive
is faulty.
Clean the drive.
Use a good tape to test the drive.
If the problem persists, replace the tape
drive.
6007 Drive n Tape Alert
7. Media Life The tape cartridge has
reached the end of its
calculated useful
Life.
Copy any data you need to another tape
Discard the old tape.
6008 Drive n Tape Alert
8. Not Data Grade The tape cartridge is not
data-grade. Any data
you back up to
the tape is at risk.
Replace the cartridge with a data-grade tape.
6009 Drive n Tape Alert
9. Write Protect You are trying to write to
a write-protected
cartridge. Remove the write-protection or use another
tape.
6012 Drive n Tape Alert
12.Unsupported
Format You have tried to load a
cartridge of a type which
is not supported by this
drive. Use another tape.
6020 Drive n Tape Alert
20. Clean Now The tape drive needs
cleaning. If the operation has stopped, eject the tape
and clean the drive
If the operation has not stopped, wait for it
to finish and then
Clean the drive.
Check the user manual for cleaning
instructions.
6022 Drive n Tape Alert
22. Expired
Cleaning Media The last cleaning
cartridge used in the
tape drive has worn out.
Discard the worn out cleaning cartridge.
Wait for the current operation to finish.
Then use a new cleaning cartridge.
6030 Drive n Tape Alert
30. Hardware A The tape drive has a
hardware fault.
Eject the tape.
Reset the drive.
Restart the operation.
6031 Drive n Tape Alert
31. Hardware B The tape drive has a
hardware fault.
Turn the tape drive off and then on again.
Restart the operation.
If the problem persists, call the tape drive
supplier helpline.
6032 Drive n Tape Alert
32. Interface The tape drive has a
problem with the host
Check the cables and cable connections.
Restart the operation.