Installation and Setup
Connecting the
Autoloader to the Server
AUTOLOADER LTO3 – User Reference Manual Rev. 1.01
TANDBERG DATA
Page 2 9 of 79
7.6 Connecting the Autoloader to the Server
The autoloader has to be attached to a SCSI/LVD system.
Cabling is required for the tape drive interface and the RMU, if installed, in order for your server (host)
to communicate with the autoloader. The following sections include information on options cabling and
drive interface connections.
7.6.1 Connecting to RMU
NOTE:
If you are plugging the RMU directly into a PC, use a special crossover Ethernet cable (not
supplied).
1. Plug an Ethernet cable into the RMU mounted on the rear of the autoloader.
2. Plug the other end of the Ethernet cable into your network switch or hub.
7.6.2 Connecting to SCSI bus
A SCSI cable is required for each server connection to a SCSI bus. An LVD SCSI terminator may be
included in your ship group.
!
!
IMPORTANT
Be sure to install the appropriate SCSI host bus adapter and software on your
server (host). For more information, see your server (host) documentation and
application software.
Connecting to a SCSI-LVD System
1. Plug the SCSI cable into the top SCSI receptacle (1) on the rear panel of your autoloader.
Figure 17
SCSI receptacles
2. Plug the LVD SCSI terminator (or another SCSI cable connecti ng to another SCSI device) into the
bottom SCSI receptacle (2) on the rear panel of your autoloader.
3. Connect the SCSI cable to your server (host).
