Tanco Autowrap 1300 M, Руководство оператора

Страница: 25 / 35

25
Tanco Autowrap 1300 S
Operator’s manual
10.4 START.
The plastic film end has to be locked in the Cutter/Film holder or tied to the bale before starting
the wrapping.
Operate the tractors single acting hydraulic lever to start the arm turning. Remember the
Reset
button on the control unit must be pressed when the control unit is switched on first to allow the
wrap arm to turn. The cutter will automatically open and close on the second turn of the arm, this
releases its hold on the plastic.
The arm will automatically go into slow speed and the cutter will open on the last turn of the arm
(as set on the control unit ,See section 3.1 and 10.6). The wrap arm should be stopped by putting
the tractors hydraulic lever back to centre when the arm passes the cutter. The cutter will
automatically close.
10.5 OVERLAP.
Ensure that the overlap is correct. If not, see chapter 9.
10.6 HOW MANY LAYERS OF PLASTIC FILM?
When the bale is completely covered with film, read the counter that displays the number of
revolutions done by the wrapping arm. This number has to be multiplied by 2 or 3, depending on
how many layers of film you want to have.
* 4 layers - multiply by 2.
* 6 layers - multiply by 3.
As long as you wrap bales with the same diameter, you can stop at the same number every time.
See section 3.1 for setting the control unit to required number of turns.
10.7 STOP.
See section 10.4 above.
The control unit allows you to deviate from its semi automatic settings as follows:
If you wish to put on some extra layers of plastic on a bale hold down the - button (on extreme left
of control unit See page 17) on the last revolution of the wrap arm, by doing this the arm will not
go into slow and open the cutter.
If you wish to put on less layers of plastic or have gone past the set number as described above,
you should press the + button (on the extreme right of the control unit) , this will put the arm into
slow speed and open the cutter, then stop the arm as it goes by the cutter.
Press the Reset button twice to reset the wrap count to zero.
10.8 STORAGE PLACE.
At the storage place the bales should be placed systematically. Start at the right-hand side, and
stack to the left. The machine is lowered, but not all the way down to the ground.
The rollers
must not hit the ground. Push the tractor hydraulic lever controlling "rollers out" and the bale
will rest on the ground. Drive the tractor carefully away from the bale. Try to avoid touching the
bale with the rollers. The plastic film will now tear off by the perforation at the cutter. Place the
next bale to the left of the first one so that the loose film end on the last bale will be locked. Then
you do not have to leave the tractor cab to fasten the loose film end. To be sure we recommend
that you check that the film ends are securely fastened, and eventually fasten them a little bit
better when you have stacked the bales.
If the machine is front mounted, the bales can be staked upon each other. (See more in chapter
3.0).