Tanco Autowrap 1300 M, Руководство оператора

Страница: 24 / 35

24
Tanco Autowrap 1300 S
Operator’s manual
10.0 OPERATING INSTRUCTIONS.
We shall now go through a complete wrapping process, from loading to storage place, and
explain the practical use of Tanco autowrap 1300.
10.1 Fitting roll of film.
Fig.: 10-2 Fig.: 10-1
ƒ
When loading a plastic roll, first ensure the top cone (2) is pushed up to latched position, then push back
the Stretch rollers (3) until held in position by locking catch (4). .
ƒ
Place the Roll on the Bottom Cone and release the top latch (1).
ƒ
Pull the film between the rollers on the pre-stretcher in the direction of the arrow. (See fig. 5-2). (See also
the sticker on the dispenser).
ƒ
Release the locking catch and allow the rollers to lie against the roll of film. Pull the film from the roll and
tie it to the bale.
10.2 LOADING.
Pick a bale to wrap. Increase the opening between the rollers as much as possible using the
Double Acting hydraulic lever in the tractor. Lower the machine almost to the ground.
Do not
lower the machine all the way down to the ground. Drive in under the bale. Close the rollers
until they begin to lift the bale. Lift the machine and the bale approx. 10-15 cm, above the ground.
Close the rollers completely.
The rollers must not under any circumstances hit the ground
while closing. The reason why the rollers shall not hit the ground is that this will increase the
wearing on the gears and the bearings of the rollers and they may also pick up dirt that will
contaminate the silage.
10.3 HEIGHT ADJUSTMENT OF TOWER / PRE-STRETCHER.
The pre-stretcher has to be adjusted so that the plastic film is always hitting the middle of the
bale.