TAMURA NT110, Инструкция по эксплуатации

Страница: 41 / 52

NT110 Instruction Manual (EN)
2D-53-0002680A
32
10-4 IO CARD Installation Method
Install IO CARD in the following procedure.
* Dissipate the static electricity from your body sufficiently before you touch anywhere
CARDs.
10-4-1 Removing Blank Panel
Remove the two screws from the Blank Panel as shown in the figure below.
*The figure shows the IO CARD mounting on the SLOT1 side.
* Removing the SLOT 2 side is the same procedure.
The blank panel will come off.
10-4-2 Install IO CARD
Insert the IO CARD straight and tighten the two places with the screw as shown in the
figure below.
* If the mounting of the screw is loose, you do not can use it in the correct state. Because
the electrical signal level is not stable.
SLOT1 side
SLOT2 side
M3x8 at 2 locations
M3x8 at 2 locations