TAMURA NT110, Инструкция по эксплуатации

Страница: 37 / 52

NT110 Instruction Manual (EN)
2D-53-0002680A
28
s
10-2 Replacing DSP CARD
10-2-1 Precautions
If two DSP CARD configuration is used, the same-version DSP CARDs must be mounted in the
Primary DSP Slot and the Secondary DSP Slot.
The involatile memory of a DSP CARD stores the Setup and Preset Program data. The stored
data may be lost if you perform a replacement procedure incorrectly or the DSP CARD fails. If a
means for emergency recovery is required, it is recommended to perform "Backup of NT110
Data." For the details of the procedure, refer to Appendix, Backing Up and Uploading NT110
Data.
Dissipate the static electricity from your body sufficiently before you touch anywhere DSP
CARDs.
10-2-2 One DSP CARD Configuration
* Perform Procedures 1 and 5 if you need to transfer the data stored in a DSP CARD (Setup and
Preset Program) to a new DSP CARD.
* To transfer only the Setup settings stored in a DSP CARD, you can record the Setup settings
before replacement and manually configure the Setup settings after replacement. In this case,
you need not perform Procedures 1 and 5.
1 Perform the procedure of "Transferring Data from NT110 to PC."
For details of the procedure, refer to Appendix, Transferring Backup Data from NT110
to PC File (Backup).
2 Turn off the NT110 power.
3 Remove the DSP CARD to be replaced and install a new DSP CARD.
4 Turn on the NT110 power.
5 Perform the procedure of "Transferring Data from PC File to NT110."
For details of the procedure, refer to Appendix, Transferring Backup Data from PC File
to NT110 (Upload).