TAMURA NT110, Инструкция по эксплуатации

Страница: 36 / 52

NT110 Instruction Manual (EN)
2D-53-0002680A
27
10. Appendix
10-1 Adding DSP CARD
10-1-1 Precautions
If two DSP CARD configuration is used, the same-version DSP CARDs must be mounted in the
Primary DSP Slot and the Secondary DSP Slot.
The involatile memory of a DSP CARD stores the Setup and Preset Program data. The stored
data may be lost if you perform a replacement procedure incorrectly or the DSP CARD fails. If a
means for emergency recovery is required, it is recommended to perform "Backup of NT110
Data." For the details of the procedure, refer to Appendix, Backing Up and Uploading NT110
Data.
Dissipate the static electricity from your body sufficiently before you touch anywhere DSP
CARDs.
10-1-2 Additional Procedure
* This procedure copies the data stored in the Primary DSP CARD (Setup and Preset Program) to
a new DSP CARD mounted in the Secondary DSP Slot.
Please keep the removed FAN CARD carefully. Fan card is necessary to restore the original
state, such as when DSP CARD fails.
1 Turn off the NT110 power.
2 Remove FAN CARD and install DSP CARD.
3 Before turning on the NT110 power, make sure that the DSP Change Over button
located at the upper right side of the touch panel is Off (not depressed).
Make sure that the button is not depressed and is in the Off status. The data stored in
the Primary DSP CARD will be lost if the button is depressed and is in the On status.
4 Turn on the NT110 power.
While the startup screen is displayed, data is transferred from the Primary DSP CARD
to the Secondary DSP CARD.
10-1-3 Operation Check after Adding
After adding, activate the DSP CARD to check the audio input/output and operation
displays.