TallyGenicom 6300 Series, Руководство по обслуживанию

Страница: 36 / 175

6300 Series Maintenance Manual
30
2.3.3.1.4 Print Gap
This option allows the platen to be aligned to the hammer bank. When the enter key is pressed the
platen goes to a value of 54. At this point, the technician will align and distance by approximately
13 mils the platen from the hammer tips. This is achieved by turning the screws on the adjust side
plates. Once this is complete, the enter key is pressed again and the platen returns to the fully
open position.
The print gap calibration and the platen sensor calibration need only be run during final assembly
of the printer and anytime a platen is replaced. If a hammer bank is replaced, only the print gap
option needs to be run.
2.3.3.1.5 Platen
This option calibrates the platen sensor to the platen motor. When the enter key is pressed the
platen motor will step through its entire rotational range. At each step the sensor reading will be
recorded. This process takes approximately 30 seconds and its progress is indicated by an
increasing bar graph on the control panel. Once completed the platen will return to the fully open
position. If errors are found in the table after the calibration has completed, the table is erased and
“Platen Sensor Fault” is displayed on the front panel.
In order for the platen sensor calibration to work properly, paper and the ribbon cartridge must be
removed. The software, however, checks for the presence of these items and will display an error
message and not start the calibration until they have been removed.
2.3.3.2 Cal-Paper
The only paper sensor that can be calibrated is the Paper Out sensor.
2.3.3.2.1 Paper Out
This parameter allows users to calibrate the paper-out detection sensor if the factory default
settings fail to detect when the paper really is out, or when false paper-out faults occur. Pressing
ENTER
will initiate a series of messages instructing the operator to calibrate the detection sensor:

Remove the paper from the printer, close the tractor door, and press
ENTER
. A numeric
value will be displayed briefly. A new message appears instructing the user to load the
printer with paper.

Press ENTER . A new numeric value is displayed briefly, ending the calibration
sequence.